Phone:
+1 877 302 8632
Fax:
+1 888 205 9894 (Toll-free)
E-Mail:
orders@antibodies-online.com

Mouse IgG1 isotype control (Orange Cytognos 515)

FACS, IsoC, IF ICIGG1 IgG1 Orange Cytognos 515
Catalog No. ABIN1112393
  • Target See all IgG1 products
    IgG1
    Host
    • 208
    • 36
    • 27
    • 9
    • 4
    • 4
    • 2
    • 1
    • 1
    Mouse
    Conjugate
    Orange Cytognos 515
    Application
    Flow Cytometry (FACS), Isotype Control (IsoC), Immunofluorescence (IF)
    Characteristics
    This mouse monoclonal IgG1 was produced against a synthetic hapten, which is normally not present in humans or animals. Therefore, this mouse IgG1 does not react with any antigen of human or animal cells.
    Clone
    • 43
    • 22
    • 17
    • 12
    • 7
    • 6
    • 6
    • 5
    • 5
    • 4
    • 3
    • 3
    • 3
    • 3
    • 2
    • 2
    • 1
    • 1
    • 1
    • 1
    • 1
    • 1
    • 1
    • 1
    • 1
    • 1
    • 1
    ICIGG1
    Isotype
    IgG1
  • Application Notes
    It is recommended for use in flow cytometry. This reagent is effective for direct immunofluorescence staining of human tissue for flow cytometric analysis using 5 µL/10^6 cells.
    Comment

    OC515 (Abs/Em Max: 405/518 nm) Direct replacement for: Pacific Orange and AmCyan.

    Sample Preparation
    1. Transfer 100 µL of anticoagulated (EDTA) blood to a 12 x 75 mm polystyrene test tube (10^6 cells). 2. Add 5 µL of Isotype Control IgG2a OC515 and mix gently with a vortex mixer. The 5 µL is a guideline only, the correct volume depends on the quantity of direct monoclonal used. 3. Incubate in the dark at room temperature at 4 °C for 30 minutes or at room temperature (20-25 °C) for 15 minutes. 4. Add 1,5 mL of Lysing Solution to each sample and mix gently with a vortex mixer. Incubate for 10 minutes at room temperature in the dark. 5. Centrifuge at 1000 x g for 5 minutes. Gently aspirate the supernatant and discard it leaving approximately 50 µL of fluid. 6. Add 2 mL 0.01 mol/l PBS (It betters that it containing 2 % bovine serum albumin) and resuspend the cells by using a vortex mixer. 7. Centrifuge at 1000 x g for 5 minutes. Gently aspirate the supernatant and discard it leaving approximately 50 µL of fluid. 8. Resuspend pellet in an appropriate fluid for flow cytometry, e.g. 0.3 mL PBS. The PBS should contain 1 % paraformaldehyde (fixative) if samples are not analysed the same day. 9. Analyse on a flow cytometer or store at 2-8 °C in the dark until analysis. Samples can be run up to 24 hours after lysis.
    Restrictions
    For Research Use only
  • Format
    Liquid
    Buffer
    The conjugate is provided in liquid form in buffer containing Antibody Stabilizer PBS 10 mM solution and 0,09 % Sodium azide, pH 7.4.
    Preservative
    Sodium azide
    Precaution of Use
    1. The device is not intended for clinical use including diagnosis, prognosis, and monitoring of a disease state, and it must not be used in conjunction with patient records or treatment. 2. This product contains Sodium azide (NaN3), a chemical highly toxic in pure form. At product concentrations, though not classified as hazardous, Sodium azide may react with lead and copper plumbing to form highly explosive build-ups of metal azides. Upon disposal, flush with large volumes of water to prevent metal azide build-up in plumbing. 3. As with any product derived from biological sources, proper handling procedures should be used.
    Handling Advice
    Avoid repeated freeze-thaw cycles.
    Avoid exposure to light.
    Storage
    4 °C
  • Target
    IgG1
    Abstract
    IgG1 Products
    Synonyms
    IgG1 Isotype Control, Igh-4 Isotype Control, VH7183 Isotype Control, immunoglobulin heavy constant gamma 1 (G1m marker) Isotype Control, Ighg1 Isotype Control
    Target Type
    Antibody
You are here:
Support