SEMA3E ELISA Kit

Catalog No. ABIN5658697

Product Details SEMA3E ELISA Kit

Target: SEMA3E (Sema Domain, Immunoglobulin Domain (Ig), Short Basic Domain, Secreted, (Semaphorin) 3E (SEMA3E))

Reactivity: Human

Detection Method: Colorimetric

Method Type: Sandwich ELISA

Detection Range: 1.25 ng/mL - 20 ng/mL

Minimum Detection Limit: 1.25 ng/mL

Application: ELISA

Sample Type: Cell Lysate, Plasma, Serum, Tissue Homogenate

Analytical Method: Quantitative

Specificity: This assay has high sensitivity and excellent specificity for detection of Semaphorin 3E (SEMA3E). No significant cross-reactivity or interference between Semaphorin 3E (SEMA3E) and analogues was observed.

Sensitivity: 0.51 ng/mL

Application Details

Comment:

The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

Assay Time: 3 h

Plate: Pre-coated

Protocol: The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Semaphorin 3E (SEMA3E). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Semaphorin 3E (SEMA3E). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Semaphorin 3E (SEMA3E), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Semaphorin 3E (SEMA3E) in the samples is then determined by comparing the O.D. of the samples to the standard curve.

Assay Precision: Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Semaphorin 3E (SEMA3E) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Semaphorin 3E (SEMA3E) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12%

Restrictions: For Research Use only

Handling

Handling Advice: The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.

Storage: 4 °C,-20 °C

Storage Comment: -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.

Expiry Date: 4-8 months

Target Details for SEMA3E

Target: SEMA3E (Sema Domain, Immunoglobulin Domain (Ig), Short Basic Domain, Secreted, (Semaphorin) 3E (SEMA3E))

Alternative Name: Semaphorin 3E (SEMA3E Products)

Synonyms: M-SEMAH ELISA Kit, M-SemaK ELISA Kit, SEMAH ELISA Kit, coll-5 ELISA Kit, 6430702L12 ELISA Kit, AA408817 ELISA Kit, Semah ELISA Kit, mKIAA0331 ELISA Kit, semaphorin 3E ELISA Kit, sema domain, immunoglobulin domain (Ig), short basic domain, secreted, (semaphorin) 3E ELISA Kit, SEMA3E ELISA Kit, Sema3e ELISA Kit

Background:

Gene Name: Semaphorin 3E

Gene Aliases: SEMAH, M-SemaK, M-sema H, coll-5, Sema Domain,Immunoglobulin Domain(Ig),Transmembrane Domain(TM)and Short Cytoplasmic Domain 3E

Gene ID: 9723

UniProt: O15041