CCL24 ELISA Kit
Quick Overview for CCL24 ELISA Kit (ABIN5657053)
Target
See all CCL24 ELISA KitsReactivity
Detection Method
Method Type
Detection Range
Application
Sample Type
-
-
Minimum Detection Limit
- 15.62 pg/mL
-
Analytical Method
- Quantitative
-
Specificity
- This assay has high sensitivity and excellent specificity for detection of Myeloid Progenitor Inhibitory Factor 2 (MPIF2). No significant cross-reactivity or interference between Myeloid Progenitor Inhibitory Factor 2 (MPIF2) and analogues was observed.
-
Sensitivity
- 6.3 pg/mL
-
-
-
-
Comment
-
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
-
Assay Time
- 3 h
-
Plate
- Pre-coated
-
Protocol
- The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Myeloid Progenitor Inhibitory Factor 2 (MPIF2). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Myeloid Progenitor Inhibitory Factor 2 (MPIF2). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Myeloid Progenitor Inhibitory Factor 2 (MPIF2), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Myeloid Progenitor Inhibitory Factor 2 (MPIF2) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
-
Assay Precision
-
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Myeloid Progenitor Inhibitory Factor 2 (MPIF2) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Myeloid Progenitor Inhibitory Factor 2 (MPIF2) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12% -
Restrictions
- For Research Use only
-
-
-
Handling Advice
- The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.
-
Storage
- 4 °C,-20 °C
-
Storage Comment
- -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.
-
Expiry Date
- 4-8 months
-
-
- CCL24 (Chemokine (C-C Motif) Ligand 24 (CCL24))
-
Alternative Name
- Myeloid Progenitor Inhibitory Factor 2
-
Background
-
Gene Name: Myeloid Progenitor Inhibitory Factor 2
Gene Aliases: CCL24, SCYA24, Ckb-6, Eotaxin-2, Chemokine C-C-Motif Ligand 24, Eosinophil chemotactic protein 2, Small Inducible Cytokine Subfamily A(Cys-Cys)Member 24
-
Gene ID
- 56221
-
UniProt
- Q9JKC0
-
Pathways
- Regulation of Actin Filament Polymerization
Target See all CCL24 ELISA Kits
-