ESM1 ELISA Kit
-
- Target See all ESM1 ELISA Kits
- ESM1 (Endothelial Cell-Specific Molecule 1 (ESM1))
-
Reactivity
- Human
- Detection Method
- Colorimetric
- Method Type
- Sandwich ELISA
- Detection Range
- 15.6 pg/mL - 1000 pg/mL
- Minimum Detection Limit
- 15.6 pg/mL
- Application
- ELISA
- Sample Type
- Cell Lysate, Plasma, Serum, Tissue Homogenate
- Analytical Method
- Quantitative
- Specificity
- This assay has high sensitivity and excellent specificity for detection of Endothelial Cell Specific Molecule 1 (ESM1). No significant cross-reactivity or interference between Endothelial Cell Specific Molecule 1 (ESM1) and analogues was observed.
- Sensitivity
- 6.2 pg/mL
- Featured
- Discover our best selling ESM1 ELISA Kit
- Top Product
- Discover our top product ESM1 ELISA Kit
-
-
- Comment
-
The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.
- Assay Time
- 3 h
- Plate
- Pre-coated
- Protocol
- The test principle applied in this kit is Sandwich enzyme immunoassay. The microtiter plate provided in this kit has been pre-coated with an antibody specific to Endothelial Cell Specific Molecule 1 (ESM1). Standards or samples are then added to the appropriate microtiter plate wells with a biotin-conjugated antibody specific to Endothelial Cell Specific Molecule 1 (ESM1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. After TMB substrate solution is added, only those wells that contain Endothelial Cell Specific Molecule 1 (ESM1), biotin-conjugated antibody and enzyme-conjugated Avidin will exhibit a change in color. The enzyme-substrate reaction is terminated by the addition of sulphuric acid solution and the color change is measured spectrophotometrically at a wavelength of 450nm ± 10nm. The concentration of Endothelial Cell Specific Molecule 1 (ESM1) in the samples is then determined by comparing the O.D. of the samples to the standard curve.
- Assay Precision
-
Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Endothelial Cell Specific Molecule 1 (ESM1) were tested 20 times on one plate, respectively
Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Endothelial Cell Specific Molecule 1 (ESM1) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
Intra-Assay: CV<10%
Inter-Assay: CV<12% - Restrictions
- For Research Use only
-
- Handling Advice
- The Stop Solution is acidic. Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.
- Storage
- 4 °C,-20 °C
- Storage Comment
- -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.
- Expiry Date
- 4-8 months
-
- Target See all ESM1 ELISA Kits
- ESM1 (Endothelial Cell-Specific Molecule 1 (ESM1))
- Alternative Name
- Endothelial Cell Specific Molecule 1 (ESM1 Products)
- Synonyms
- ESM1 ELISA Kit, zgc:153027 ELISA Kit, 0610042H23Rik ELISA Kit, AV004503 ELISA Kit, ESM-1 ELISA Kit, Pg25 ELISA Kit, endocan ELISA Kit, endothelial cell specific molecule 1 ELISA Kit, endothelial cell-specific molecule 1 ELISA Kit, ESM1 ELISA Kit, esm1 ELISA Kit, Esm1 ELISA Kit
- Background
-
Gene Name: Endothelial Cell Specific Molecule 1
Gene Aliases: Endocan
- Gene ID
- 11082
- UniProt
- Q9NQ30
- Pathways
- Growth Factor Binding
-