Phone:
+1 877 302 8632
Fax:
+1 888 205 9894 (Toll-free)
E-Mail:
orders@antibodies-online.com

PAI1 CLIA Kit

SERPINE1 Reactivity: Human Chemiluminescent Sandwich ELISA 7.81 pg/mL - 2000 pg/mL Cell Culture Supernatant, Cell Lysate, Plasma, Tissue Homogenate
Catalog No. ABIN5657855
  • Target See all PAI1 (SERPINE1) CLIA Kits
    PAI1 (SERPINE1) (Plasminogen Activator Inhibitor 1 (SERPINE1))
    Reactivity
    • 10
    • 7
    • 5
    • 3
    • 3
    • 3
    • 3
    • 2
    • 2
    • 1
    • 1
    • 1
    • 1
    • 1
    Human
    Detection Method
    Chemiluminescent
    Method Type
    Sandwich ELISA
    Detection Range
    7.81 pg/mL - 2000 pg/mL
    Minimum Detection Limit
    7.81 pg/mL
    Application
    ELISA
    Sample Type
    Cell Culture Supernatant, Cell Lysate, Plasma, Tissue Homogenate
    Analytical Method
    Quantitative
    Specificity
    This assay has high sensitivity and excellent specificity for detection of Plasminogen Activator Inhibitor 1 (PAI1). No significant cross-reactivity or interference between Plasminogen Activator Inhibitor 1 (PAI1) and analogues was observed.
    Sensitivity
    0.96 pg/mL
    Featured
    Discover our best selling SERPINE1 ELISA Kit
    Top Product
    Discover our top product SERPINE1 ELISA Kit
  • Comment

    The stability of kit is determined by the loss rate of activity. The loss rate of this kit is less than 5 % within the expiration date under appropriate storage condition. To minimize extra influence on the performance, operation procedures and lab conditions, especially room temperature, air humidity, incubator temperature should be strictly controlled. It is also strongly suggested that the whole assay is performed by the same operator from the beginning to the end.

    Assay Time
    2 - 3 h
    Plate
    Pre-coated
    Protocol
    The microplate provided in this kit has been pre-coated with an antibody specific to Plasminogen Activator Inhibitor 1 (PAI1). Standards or samples are then added to the appropriate microplate wells with a biotin-conjugated antibody specific to Plasminogen Activator Inhibitor 1 (PAI1). Next, Avidin conjugated to Horseradish Peroxidase (HRP) is added to each microplate well and incubated. Then the mixture of substrate A and B is added to generate glow light emission kinetics. Upon plate development, the intensity of the emitted light is proportional to the Plasminogen Activator Inhibitor 1 (PAI1) level in the sample or standard.,
    Assay Precision
    Intra-assay Precision (Precision within an assay): 3 samples with low, middle and high level Plasminogen Activator Inhibitor 1 (PAI1) were tested 20 times on one plate, respectively
    Inter-assay Precision (Precision between assays): 3 samples with low, middle and high level Plasminogen Activator Inhibitor 1 (PAI1) were tested on 3 different plates, 8 replicates in each plate. CV(%) = SD/meanX100
    Intra-Assay: CV<10%
    Inter-Assay: CV<12%
    Restrictions
    For Research Use only
  • Handling Advice
    Do not allow to contact skin or eyes. Calibrators, controls and specimen samples should be assayed in duplicate. Once the procedure has been started, all steps should be completed without interruption.
    Storage
    4 °C,-20 °C
    Storage Comment
    -20°C. Bring all reagents to room temperature before beginning test. The kit may be stored at 4°C for immediate use within two days upon arrival. Reseal any unused strips with desiccant pack. Minimize freeze/thaw cycles.
    Expiry Date
    4-8 months
  • Target See all PAI1 (SERPINE1) CLIA Kits
    PAI1 (SERPINE1) (Plasminogen Activator Inhibitor 1 (SERPINE1))
    Alternative Name
    Plasminogen Activator Inhibitor 1 (SERPINE1 Products)
    Synonyms
    PAI CLIA Kit, PAI-1 CLIA Kit, PAI1 CLIA Kit, PLANH1 CLIA Kit, SERPINE1 CLIA Kit, si:ch211-138a11.1 CLIA Kit, Planh1 CLIA Kit, PAI1A CLIA Kit, Pai1 CLIA Kit, Pai1aa CLIA Kit, Planh CLIA Kit, RATPAI1A CLIA Kit, serpin family E member 1 CLIA Kit, serpin peptidase inhibitor, clade E (nexin, plasminogen activator inhibitor type 1), member 1 L homeolog CLIA Kit, serpin peptidase inhibitor, clade E (nexin, plasminogen activator inhibitor type 1), member 1 CLIA Kit, serine (or cysteine) peptidase inhibitor, clade E, member 1 CLIA Kit, SERPINE1 CLIA Kit, serpine1.L CLIA Kit, serpine1 CLIA Kit, Serpine1 CLIA Kit
    Background

    Gene Name: Plasminogen Activator Inhibitor 1

    Gene Aliases: SERPINE1, PLANH1, Serpin Peptidase Inhibitor Clade E Member 1, Nexin,Plasminogen Activator Inhibitor Type 1 Serpin E1, Endothelial plasminogen activator inhibitor

    Gene ID
    5054
    UniProt
    P05121
    Pathways
    p53 Signaling, Cellular Response to Molecule of Bacterial Origin, Carbohydrate Homeostasis, Autophagy, Smooth Muscle Cell Migration
You are here:
Support